The SimpleSwitch Connectivity feature lets you set your scanner to run as a non-network scanner (USB mode), or as a network enabled scanner using either an Ethernet connection or RNDIS (“Ethernet over USB”).
Follow the instructions below to set your scanner to the correct mode BEFORE turning it on for the first time.
If you need to switch your scanner from network to non-network mode or vice versa after it has already been set up, see the “Changing Modes with SimpleSwitch” section at the end of this page, or watch a short tutorial video here.
USB Mode
 |
 |
 |
Ethernet Mode
|
 |
 |
RNDIS Mode
|
|
 |
Step 1: Press the power button and hold for several seconds.
Step 2: Wait until you hear an audible “chirp.”
Step 3: Continue holding the button for several more seconds.
Step 4: Wait for a second chirp.
The scanner will power off and will restart next time in the opposite connection mode.
 |  | | |
